Click Here for AirGunHome.com Main Page
Argentina Australia Belgium Canada Chile Denmark France Germany Greece India
Italy Mexico New Zealand Netherlands Norway Russian Federation South Africa Spain Turkey United Kingdom United States
AirGunHome.com: THE Worldwide Airgun Forum


AirGunSeals.com Main Page Link
Air Gun Home Forum Index Register FAQ Memberlist Search

Air Gun Home Forum Index » Airgun Smithing » Got the mill finished
Post new topic  Reply to topic View previous topic :: View next topic 
Got the mill finished 
PostPosted: Tue Feb 09, 2010 2:50 am Reply with quote
kanyon
Silver Status Member
Silver Status Member
Joined: 09 Aug 2008
Posts: 1582
Location: New Zealand
Taken a while...But its cut its first slot today..

After a bit of shimming under the table I managed to get to to with
in .1mm...But I think I will build a new table the slides are a bit short..

The head rotates and slides fore & aft...
& has a MT2 tapper with draw bolt....

As long as yer don't cut any deeper than 2mm its
pretty good...alloy / steel / plastic OK but it dosen't like
stainless steel...

a new table is a must..I think...
now just a collet chuck & a depth DRO..

1st job build a PCP.... Razz

Pete






View user's profile Send private message MSN Messenger
 
PostPosted: Tue Feb 09, 2010 7:59 pm Reply with quote
fritz
Silver Status Member
Silver Status Member
Joined: 25 Nov 2008
Posts: 2444
Location: New Jersey- outside of Philadelphia
Sexy. Mr. Green

_________________
"I never set out to be wierd, it was always everyone else who called me it" -Frank Zappa

Speed is impressive, accuracy is deadly.

It's not that I'm not a people person, it's just that I'm not a stupid people person.
View user's profile Send private message AIM Address MSN Messenger
 
PostPosted: Fri Feb 12, 2010 1:15 pm Reply with quote
Alstone
Moderator & Site Supporter
Moderator & Site Supporter
Joined: 01 Mar 2007
Posts: 4139
Location: Linconshire, ENGLAND
Nice job Pete, and 2mm is good enough for most things, unless your going to do production runs and time is the essence.

Al Thumb Up!

_________________


View user's profile Send private message ICQ Number
Got the mill finished 
  Air Gun Home Forum Index » Airgun Smithing
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
All times are GMT - 5 Hours  
Page 1 of 1  

  
  
 Post new topic  Reply to topic  

Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.


Click Here for AirGunHome.com Main Page


Powered by phpBB © 2001-2004 phpBB Group
Partial Styling Supplied by Vjacheslav Trushkin Themes Database.