 |  | | | |  |  |  |  | Got the mill finished |  | |  |  |  |
Posted: Tue Feb 09, 2010 2:50 am |
|
|
| kanyon |
| Silver Status Member |

|
 |
| Joined: 09 Aug 2008 |
| Posts: 1582 |
| Location: New Zealand |
|
|
 |
Taken a while...But its cut its first slot today..
After a bit of shimming under the table I managed to get to to with
in .1mm...But I think I will build a new table the slides are a bit short..
The head rotates and slides fore & aft...
& has a MT2 tapper with draw bolt....
As long as yer don't cut any deeper than 2mm its
pretty good...alloy / steel / plastic OK but it dosen't like
stainless steel...
a new table is a must..I think...
now just a collet chuck & a depth DRO..
1st job build a PCP....
Pete
 |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Tue Feb 09, 2010 7:59 pm |
|
|
| fritz |
| Silver Status Member |

 |
 |
| Joined: 25 Nov 2008 |
| Posts: 2444 |
| Location: New Jersey- outside of Philadelphia |
|
|
 |
Sexy.  |
|
_________________ "I never set out to be wierd, it was always everyone else who called me it" -Frank Zappa
Speed is impressive, accuracy is deadly.
It's not that I'm not a people person, it's just that I'm not a stupid people person. |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Fri Feb 12, 2010 1:15 pm |
|
|
| Alstone |
| Moderator & Site Supporter |

 |
 |
| Joined: 01 Mar 2007 |
| Posts: 4139 |
| Location: Linconshire, ENGLAND |
|
|
 |
Nice job Pete, and 2mm is good enough for most things, unless your going to do production runs and time is the essence.
Al  |
|
_________________
 |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | Got the mill finished |  | |  |  |  |
Air Gun Home Forum Index » Airgun Smithing
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|