| | | | | | | | | IZH-61 rebuild, what parts are needed? | | | | | |
Posted: Wed May 17, 2017 7:35 pm |
|
|
rcmartin |
Member |
|
|
Joined: 13 Jun 2011 |
Posts: 49 |
|
|
|
|
What parts are needed to do a rebuild.
What parts wear and should be replaced?
So far I figure I need these two:
IZH61 Mainspring - (#13) #301011
IZH61 Piston Seal - (#10) #301008
What else should I replace as long as I have the gun apart?
Parts Diagram:
http://www.eaacorp.com/diagrams-izh61lg.html
Thanks for any advice! |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
Posted: Fri May 19, 2017 6:14 am |
|
|
AirGunEric |
Site Admin |
|
|
Joined: 20 Jan 2007 |
Posts: 6908 |
Location: "Out There" |
|
|
|
Not familiar with the 61, but I would assume there is some sort of breech seal- but I don't see any on that diagram (?) |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
Posted: Sat Jun 03, 2017 11:58 am |
|
|
dobiman |
Veteran Member |
|
|
Joined: 30 Mar 2010 |
Posts: 167 |
Location: Gil's Isle, USA |
|
|
|
It seems there isn't much more to change. There is no breech seal, just metal to metal pellet feeding pin. There seems to be little that you can do to upgrade power too. It will not take a stronger spring without causing damage to the cocking lever. The piston and piston seal seems to be already at optimum. |
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|