 |  | | | |  | |  |  | Home built budget swing/spinners |  | |  |  | |
 Posted: Sun Jul 07, 2013 1:36 pm |
 |
|
| paddyfritz |
| Member |
 |
|
| Joined: 26 Jul 2009 |
| Posts: 99 |
| Location: Northern Ontario |
|
|
|
Made this swing/spinner target from junk for less than 7.00 inc tax.
The targets are quite thick, so although they can swing, they will only flip a bit without high fpe.
The targets were scrounged from the base of a floor lamp. The pipe sections are cut from co2 cartridges. The rod and nuts I bought at TSC, 20% off right now.
 |
|
|
|
|
|
|
| |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
