 |  | | | |  | |  |  | Yet another remington airmaster 77/crosman 2100 question |  | |  |  | |
 Posted: Tue May 03, 2011 8:59 am |
 |
|
| Macruadhi |
| New Member |
|
|
| Joined: 03 May 2011 |
| Posts: 4 |
|
|
|
|
| Ok, I've taken the pump tube apart and am looking at what I would call a pump piston, the part that is attached to the pump arm, it's listed as part number 2200E16. Does anyone know what material is used right behind the rubber cap are the end facing the pump cap. It looks like leather, but I'm not sure. |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Tue May 03, 2011 10:13 am |
|
|
| AirGunEric |
| Site Admin |
 |
|
| Joined: 20 Jan 2007 |
| Posts: 6930 |
| Location: "Out There" |
|
|
|
?
#1: Never leave digits out of part numbers- i.e. 2200E016 does not become "2200E16"- this causes all sorts of issues if you try to order something.
As for your question, I assume you are talking about the ring around the housing (could be sponge or felt)- it isn't actually required and was only there to brush oil around and to try and keep dirt from getting to the cup (neither of which it does very well). |
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
