Air Gun Home :: View topic

robert w · Senior Member

I ended up getting a new old beeman 1064 rs2 . it was out of warranty . but it had severe trouble. the breech angle was cut wrong. the breech seal was tight at the top area but had a .05 gap on the bottom area. I contacted beeman. I was told the serial number showed it was 1 on a pallet of guns that missed q.c. they told me if I could fix it they would send me the parts. I ask for a breech seal, piston seal, a barrel n breech block assembly. I paid for the seals they sent the rest, I got the parts in and got a hu8ge suprize there was 2 piston seals, 6 breech seals, 1 complete barrel assembly. now I was shocked. I had stripped the barrel down and now I have a lot of extra parts . muzzle break cocking lever n pin . wow . anyway I did the usual deburr n polish the spring ends . I lubed it lightly. I used my broken Arkansas stone on all parts in the trigger that rub , push and pull. I got it back together and shot it enough to get the scope setting right. the trigger is a 2 screw trigger. I got it set where its a short 2 pound pull to first stage then a 2.5 pound pull to break with no overtravel . its a real crisp snap when it breaks pulling the trigger . it looks like its goin to be a keepr. when it gets warm its getting cronied . I think this is another overlooked rifle Very Happy