 |  | | | |  | |  |  | Crosman 1322 barrel |  | |  |  | |
 Posted: Sat Jan 28, 2012 3:26 pm |
 |
|
| GeepII |
| Member |
 |
|
| Joined: 14 Jan 2012 |
| Posts: 63 |
| Location: Martinsburg, WV. |
|
|
|
Can anyone on here tell me how to get the barrel off my 1322? I have the front site off and the pump handle but dont have a clue on how to get the barrel out of the rear piece where the bolt is.
Any help will be greatly appreciated.
GeepII |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Sat Jan 28, 2012 3:59 pm |
|
|
| AirGunEric |
| Site Admin |
 |
|
| Joined: 20 Jan 2007 |
| Posts: 6930 |
| Location: "Out There" |
|
|
|
Rear piece were the bolt is the "breech". Is this a rear-cocking knob version, or a bolt-pull version? Is the breech plastic or steel?
The easy answer is that you need to remove the breech from the tube, and, depending on which breech you have, possibly take a screw out to release the barrel- if no screw, it is only the transfer port sleeve holding it in place once the breech is off the tube. |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | 1322 | | | | | |
| Posted: Sat Jan 28, 2012 4:08 pm |
|
|
| GeepII |
| Member |
|
|
| Joined: 14 Jan 2012 |
| Posts: 63 |
| Location: Martinsburg, WV. |
|
|
|
Thanks Airguneric, your right there is a screw down inside where the bolt slides and now I have it apart thanks buddy.
GeepII |
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
