No more guess work on finding horizontal Dead Center with your rotary table and Mill
Easy solution...
Spin two pices of true round stock to a point on your lathe...
Place one in the drill chuck on your mill
Place the other in your rotary table chuck...
Adjust your x-y table till just the tips touch...
Now your dead center...
If you will be moving back and forth on your stock... you can move the guides you made in and out of your rotary table chuck to check to see if your rotary table is centered on your x-y table...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
All times are GMT - 5 Hours
Page 1 of 1
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.