 |  | | | |  | |  |  | Crosman AirSource 1077 adapter upgrade kit |  | |  |  | |
 Posted: Tue Jan 26, 2010 7:59 pm |
 |
|
| donec |
| Senior Member |
|
|
| Joined: 19 Dec 2009 |
| Posts: 836 |
| Location: central Texas Pflugerville area |
|
|
|
| I saw the Crosman AirSource 1077 adapter upgrade kit at Pyramydair and was wondering if anyone had tried or knew if it could be adapted to use on the 1760se? |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Tue Jan 26, 2010 10:38 pm |
|
|
| AirGunEric |
| Site Admin |
 |
|
| Joined: 20 Jan 2007 |
| Posts: 6929 |
| Location: "Out There" |
|
|
|
| The 'key' to the 1077 AS adapter is that it's screw fitting is matched to the thread on the 1077 and the small tube that goes into the Co2 tube has to meet up with the valve end/seal. The 1760 tube is longer than the 1077 tube from threads to valve (or piercing assembly on the 1077) so it will not work. If you were a good pressure welder, I'm sure it would be a pretty easy alteration to add some feed tube to make it work- but for that amount of hassle, you could likely make one from the ground up anyways. |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
| Posted: Tue Jan 26, 2010 10:44 pm |
|
|
| donec |
| Senior Member |
|
|
| Joined: 19 Dec 2009 |
| Posts: 836 |
| Location: central Texas Pflugerville area |
|
|
|
| I kind of thought it may be that way. Thanks |
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
