 |  | | | |  |  |  |  | San Anselmo FWB 127 seal |  | |  |  |  |
Posted: Fri Oct 30, 2015 7:35 am |
|
|
| kim |
| New Member |

|
 |
| Joined: 10 Aug 2015 |
| Posts: 4 |
|
|
|
 |
| Just bought a San Anselmo FWB 127, it needs a lot of restoration but metal looks really well (sadly the original stock is missing and was replaced with a hand made new stock), to my surprise the piston seal is not the "normal" stem type, it uses the old stye seal with a screw in the middle to hold it in place. Not sure what seal should I ask for, my measurment is 27.7 mm in diameter, so a 28 mm would work? |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Fri Oct 30, 2015 7:34 pm |
|
|
| AirGunEric |
| Site Admin |

 |
 |
| Joined: 20 Jan 2007 |
| Posts: 6931 |
| Location: "Out There" |
|
|
 |
| Yes, it you can find one with the proper hole in the center to fit the screw. |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Fri Oct 30, 2015 9:54 pm |
|
|
| kim |
| New Member |

|
 |
| Joined: 10 Aug 2015 |
| Posts: 4 |
|
|
|
 |
| Maccari and vortex offer 28 mm seals for Diana 350 rifles, any recommendation |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Tue Nov 03, 2015 7:50 pm |
|
|
| AirGunEric |
| Site Admin |

 |
 |
| Joined: 20 Jan 2007 |
| Posts: 6931 |
| Location: "Out There" |
|
|
 |
| Depends on the hole size in the center- FWB is not Diana- I have no knowledge of the inner diameter of the seal on a 127 (it is likely not too common a question anywhere). The seal off the piston, take a picture and post it, with measurements- then people can better inform you what should fit. |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|